Concrete brick pavers can be a great addition to any walkway, patio, or home driveway. Made to last, concrete brick pavers are extremely durable and can withstand even the worst weather when kept well maintained. However, there are times when even the best brick pavers naples options can end up cracking or breaking. So what do you do when one of your paving stones needs repair? Fortunately, most of the time you’ll be able to do the job yourself. If you’re dealing with a cracked, worn, or uneven paving stone, here are a few ways to get it back to its original state in no time.
Lift the Broken Stone
When you encounter a crack, the first thing to do is inspect the damage to see how deep it goes. Since concrete is a famously durable substance, it’s very hard to fully break apart a paver. However, if you have a deep crack that can’t be mended just by using sand, you’ll need to remove the entire stone to make way for a replacement. The best way to do this is to use a sledgehammer to help loosen the area around the stone until you’re able to lift it. Concrete pavers aren’t too heavy, so you should be able to do this without help. If your stone is completely stuck, you may have to break the mortar to get inside.
Use Mortar or Dry Mix
If you’re simply dealing with a loose or uneven paver, you can fix the problem by filling in the cracks with polymeric sand or mortar. If you’re using mortar, remove the uneven paver and chip away at any old filler that may remain so you’ll have more room to work with. Afterward, fill in the gap with mortar or sand to create a more level surface. After achieving the desired height, you can put your paver back and adjust it until it’s even. If you’re working with a cracked surface, use mortar or sand to fill the crack and pave over the damaged area.
Sometimes, when brick pavers aren’t installed professionally, they can end up coming loose or become uneven over time. The best way to fix this is to level the ground and create a new, even surface. If the damage is affecting more than one brick, you’ll need to use a leveling tool like a furring strip to make sure you’re repositioning the bricks evenly. After prying any affected bricks loose with a screwdriver or small blunt tool, you’ll need to level out the bottom layer either with sand or mortar. Make sure you’re creating an even surface before repositioning your bricks and set them down. Fill any extra gaps with polymeric sand and brush off the excess before wetting.
If you’re just dealing with one small area of a chipped brick or concrete edge, you’ll be able to easily patch it over using mortar or caulking. However, if you’re worried about creating an uneven surface, you might want to consider replacing the broken brick altogether and adding a fresh one.